INSTALL REAR ROOF NO. 1 AIR DUCT (w/ Rear Air Conditioning System)
INSTALL REAR NO. 2 SEAT HEADREST ASSEMBLY LH (w/ Rear Center Seat Headrest)
Rear No. 2 Seat Assembly (Except Face To Face Seat Type) -- Installation |
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1. INSTALL REAR SEAT LOCK STRIKER SUB-ASSEMBLY |
Install the 4 seat lock strikers with 8 bolts.
- Torque:
- 37 N*m{377 kgf*cm, 27 ft.*lbf}
Return the floor carpet to its original position.
| 2. INSTALL NO. 3 SEAT CUSHION COVER |
Attach the 16 claws and 4 clips to install the 4 seat cushion covers.
| 3. INSTALL FOLD SEAT LEG LOCK SUB-ASSEMBLY |
Install the fold seat leg lock with the 2 nuts.
- Torque:
- 12 N*m{122 kgf*cm, 9 ft.*lbf}
Attach the 2 cable clamps.
| 4. INSTALL REAR ROOF NO. 1 AIR DUCT (w/ Rear Air Conditioning System) |
 |
Install the duct with the clip.
Attach the 2 claws to install the cooler plate.
 |
| 5. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH |
Attach the 4 claws to install the seat lock control lever.
| 6. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH |
w/ Sliding Roof:
Install the front quarter trim panel assembly LH (Click here).
w/o Sliding Roof:
Install the front quarter trim panel assembly LH (Click here).
| 7. INSTALL REAR SEAT COVER CAP |
- HINT:
- Use the same procedure for rear seat cover caps.
Attach the 3 claws to install the rear seat cover cap.
 |
| 8. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE |
 |
Attach the 6 clips to install the rear floor mat support plate.
| 9. INSTALL REAR DOOR SCUFF PLATE LH |
 |
Attach the 3 claws and 4 clips to install the rear door scuff plate LH.
Install the screw.
| 10. INSTALL REAR STEP COVER |
- HINT:
- Use the same procedure for both rear step covers.
Attach the 2 claws to install the rear step cover.
 |
| 11. INSTALL REAR NO. 2 SEAT ASSEMBLY |
 |
Temporarily install the seat assembly with the 4 bolts.
- NOTICE:
- Be careful not to damage the vehicle body.
Tighten the bolts in the order shown in the illustration.
- Torque:
- 37 N*m{377 kgf*cm, 27 ft.*lbf}
| 12. INSTALL REAR NO. 2 SEAT HINGE COVER LH |
Attach the clip and 2 claws to install the cover.
| 13. INSTALL REAR SEAT CUSHION HINGE COVER LH |
Attach the 3 claws to install the cover.
Return the seat to the upright position.
| 14. INSTALL REAR NO. 2 SEAT HEADREST ASSEMBLY LH (w/ Rear Center Seat Headrest) |