Rear No. 1 Seat Assembly (For 60/40 Split Seat Type 40 Side) Disassembly
Seat. Land Cruiser. Urj200, 202 Grj200 Vdj200
REMOVE SEAT ADJUSTER BOLT COVER
REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
REMOVE REAR NO. 1 SEAT RECLINING COVER RH
REMOVE REAR NO. 1 SEAT RECLINING COVER LH
REMOVE UPPER SEAT TRACK RAIL COVER LH
REMOVE UPPER SEAT TRACK RAIL COVER RH
REMOVE NO. 1 SEAT CUSHION COVER
REMOVE REAR NO. 2 SEAT LEG SIDE COVER
REMOVE FOLD SEAT STOPPER BAND ASSEMBLY
REMOVE REAR SEAT SIDE HINGE FEMALE COVER
REMOVE REAR SEAT SIDE HINGE MALE COVER LH
REMOVE REAR SEAT SIDE HINGE MALE COVER RH
REMOVE REAR NO. 2 SEAT PROTECTOR
REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
REMOVE REAR SEAT COVER
REMOVE REAR UNDER SIDE COVER LH
REMOVE NO. 1 SEAT CUSHION PLATE
REMOVE REAR SEAT UNDER TRAY COVER RH
REMOVE REAR SEAT TRACK HANDLE SUB-ASSEMBLY
REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
REMOVE SEAT CUSHION COVER WITH PAD
REMOVE REAR SEPARATE TYPE SEAT CUSHION COVER
REMOVE REAR SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
REMOVE REAR SEATBACK COVER
REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH
REMOVE REAR SEAT HEADREST ASSEMBLY
REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
REMOVE SEATBACK COVER WITH PAD
REMOVE REAR SEPARATE TYPE SEATBACK COVER
REMOVE REAR SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)
REMOVE REAR SEAT RECLINING COVER LH
REMOVE REAR SEAT RECLINING COVER RH
REMOVE REAR NO. 2 SEAT RECLINING COVER LH
REMOVE REAR NO. 1 SEAT RECLINING COVER RH
REMOVE RECLINING ADJUSTING CABLE ASSEMBLY RH
REMOVE NO. 1 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY
REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY RH
REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY
REMOVE REAR SEAT CUSHION HOLDER BRACKET RH (w/ Seat Heater System)
REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH (w/ Seat Heater System)
REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY RH
REMOVE REAR NO. 1 SEAT LOCK CONTROL LEVER
Rear No. 1 Seat Assembly (For 60/40 Split Seat Type 40 Side) -- Disassembly |
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
1. REMOVE SEAT ADJUSTER BOLT COVER |
Using a screwdriver, detach the 2 claws and remove the cover.
- HINT:
- Tape the screwdriver tip before use.
2. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH |
Remove the screw and release handle.
3. REMOVE REAR NO. 1 SEAT RECLINING COVER RH |
Remove the 2 screws.
Detach the 3 claws in the order shown in the illustration, and then remove the cover.
4. REMOVE REAR NO. 1 SEAT RECLINING COVER LH |
Remove the 2 screws.
Detach the 4 claws and remove the cover.
5. REMOVE UPPER SEAT TRACK RAIL COVER LH |
Using a screwdriver, detach the 2 claws and remove the cover.
- HINT:
- Tape the screwdriver tip before use.
6. REMOVE UPPER SEAT TRACK RAIL COVER RH |
Using a screwdriver, detach the 2 claws and remove the cover.
- HINT:
- Tape the screwdriver tip before use.
7. REMOVE NO. 1 SEAT CUSHION COVER |
Detach the 4 claws and remove the 2 covers.
8. REMOVE REAR NO. 2 SEAT LEG SIDE COVER |
Remove the 4 screws and detach the 3 claws.
Remove the bolt that is securing the fold seat stopper band and remove the seat leg side cover together with the fold seat stopper band.
9. REMOVE FOLD SEAT STOPPER BAND ASSEMBLY |
Remove the fold seat stopper band from the seat leg side cover.
10. REMOVE REAR SEAT SIDE HINGE FEMALE COVER |
Using a screwdriver, detach the 6 claws and remove the 2 covers.
- HINT:
- Tape the screwdriver tip before use.
11. REMOVE REAR SEAT SIDE HINGE MALE COVER LH |
Detach the clip and remove the cover.
12. REMOVE REAR SEAT SIDE HINGE MALE COVER RH |
Detach the clip and remove the cover.
13. REMOVE REAR NO. 2 SEAT PROTECTOR |
w/ Rear Seat Side Airbag:
Detach the claw and remove the wire harness connector.
w/ Seat Heater System:
Detach the claw and remove the wire harness connector.
Using a clip remover, remove the clip.
Detach the claw and remove the seat protector from the seat hinge.
Detach the 2 claws, open the protector and remove the wire harness.
14. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH |
Remove the 2 nuts and hinge.
15. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH |
w/ Rear Seat Side Airbag:
Detach the wire harness clamp.
w/ Seat Heater System:
Detach the wire harness clamp.
Remove the 2 nuts and hinge.
Detach the cable clamp and disconnect the cable.
16. REMOVE REAR SEAT COVER |
Detach the 12 claws.
Remove the 3 screws.
Detach the 2 claws and remove the cover.
17. REMOVE REAR UNDER SIDE COVER LH |
Remove the 5 screws.
Detach the clip and 2 claws, and remove the cover.
18. REMOVE NO. 1 SEAT CUSHION PLATE |
Detach the 3 claws and remove the seat cushion plate.
19. REMOVE REAR SEAT UNDER TRAY COVER RH |
Remove the 2 screws.
Detach the 4 claws and remove the cover.
20. REMOVE REAR SEAT TRACK HANDLE SUB-ASSEMBLY |
Remove the 2 screws and seat track handle.
Detach the 2 cable clamps and disconnect the 2 cables.
Detach the cable clamp and disconnect the cable.
21. REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY |
22. REMOVE SEAT CUSHION COVER WITH PAD |
w/ Rear Seat Side Airbag:
Detach the side airbag wire harness clamps.
Remove the side airbag wire harness through the hole in the seat cushion.
w/ Seat Heater System:
Disconnect the 2 seat heater connectors.
Remove the seatback heater wire harness through the hole in the seat cushion.
Remove the seat cushion cover with pad.
23. REMOVE REAR SEPARATE TYPE SEAT CUSHION COVER |
Detach the 3 pieces of fastening tape.
Remove the hog rings and cover.
24. REMOVE REAR SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System) |
Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.
25. REMOVE REAR SEATBACK COVER |
Using a screwdriver, detach the 4 claws and remove the cover.
- HINT:
- Tape the screwdriver tip before use.
26. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH |
Detach the 2 claws on the top of the board.
Pull up the board to detach the 2 claws on the bottom of the board and remove it.
27. REMOVE REAR SEAT HEADREST ASSEMBLY |
28. REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY |
Detach the 4 claws and remove the 2 supports.
29. REMOVE SEATBACK COVER WITH PAD |
Remove the hog rings.
w/ Rear Seat Side Airbag:
Remove the cap nut and seatback cover bracket from the seat frame.
Remove the side airbag wire harness through the hole in the seatback.
w/ Seat Heater System:
Cut the cable tie and disconnect the seatback heater wire harness.
Remove the seatback heater wire harness through the hole in the seatback.
Remove the seatback cover with pad.
30. REMOVE REAR SEPARATE TYPE SEATBACK COVER |
w/ Rear Seat Side Airbag:
Disconnect the seatback cover bracket from the seatback pad.
Remove the hog rings and rear seatback cover.
31. REMOVE REAR SEATBACK HEATER ASSEMBLY (w/ Seat Heater System) |
Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.
32. REMOVE REAR SEAT RECLINING COVER LH |
Remove the screw.
Detach the claw and remove the cover.
33. REMOVE REAR SEAT RECLINING COVER RH |
Remove the screw.
Detach the claw and remove the cover.
34. REMOVE REAR NO. 2 SEAT RECLINING COVER LH |
Remove the screw.
Detach the clamp and remove the cover.
35. REMOVE REAR NO. 1 SEAT RECLINING COVER RH |
Remove the screw.
Detach the claw and remove the cover.
36. REMOVE RECLINING ADJUSTING CABLE ASSEMBLY RH |
Detach the 2 cable clamps and disconnect the cable.
Detach the clamp and remove the adjusting cable.
37. REMOVE NO. 1 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY |
Detach the 2 cable clamps and disconnect the cable.
Detach the clamp and remove the lock control cable.
38. REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY RH |
Using a T40 "TORX" socket, remove the 4 bolts.
Remove the seatback frame.
39. REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY |
Detach the 2 cable clamps and disconnect the 2 cables.
Remove the 2 fold seat lock control cables.
40. REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY |
Remove the 2 nuts and lower seat track bracket.
Remove the 2 nuts and lower seat track bracket.
Detach the 3 cable clamps and disconnect the 3 cables.
Detach the clamp and remove the seat lock cable.
41. REMOVE REAR SEAT CUSHION HOLDER BRACKET RH (w/ Seat Heater System) |
Disconnect the seat wire connector.
Remove the 2 screws and holder bracket.
42. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH (w/ Seat Heater System) |
Detach the 2 claws and remove the seat heater control.
43. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH |
Remove the bolt and belt.
44. REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY RH |
Using a T40 "TORX" socket, remove the bolt.
Remove the 5 nuts and seat cushion frame.
45. REMOVE REAR NO. 1 SEAT LOCK CONTROL LEVER |
Remove the bolt and lock control lever.