Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Lighting (Ext). Land Cruiser. Urj200, 202 Grj200 Vdj200
Hazard Warning Switch -- Removal |
- HINT:
- Use the same procedures for the RHD and LHD.
- The procedures listed below are the LHD side.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY |
 |
Detach the 8 claws and remove the opening cover.
| 3. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY |
 |
Place protective tape as shown in the illustration.
Text in Illustration *1 Protective Tape
Using a moulding remover, detach the 6 claws.
Disconnect the connector and remove the No. 3 instrument panel register.
| 4. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY |
 |
Place protective tape as shown in the illustration.
Text in Illustration *1 Protective Tape
Using a moulding remover, detach the 6 claws.
Disconnect the connector and remove the No. 4 instrument panel register.
| 5. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver) |
Remove the 2 screws and 2 bolts.
 |
Disconnect the connectors and remove the radio receiver.
| 6. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver) |
 |
Detach the 10 claws.
Disconnect the connector and remove the No. 1 center instrument cluster finish panel.
| 7. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
Detach the 2 claws and remove the hazard warning switch.
 |