Headlight Dimmer Switch Removal

Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Lighting (Ext). Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE SPIRAL CABLE

  3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

  4. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

Headlight Dimmer Switch -- Removal


HINT:
  1. Use the same procedures for the RHD and LHD.
  2. The procedures listed below are the LHD.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE SPIRAL CABLE

  1. Remove the spiral cable (Click here).



3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Using a screwdriver, detach the claw and remove the windshield wiper switch.

    HINT:
    Tape the screwdriver tip before use.
    NOTICE:
    If the claw is pressed forcefully, it will break.


4. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Disconnect the connector.



    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. While loosening the band clamp as shown in the illustration, detach the claw to remove the dimmer switch.

    NOTICE:
    If the claw is pressed forcefully, it will break.