Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Supplemental Restraint Systems. Land Cruiser. Urj200, 202 Grj200 Vdj200
Rear Floor Airbag Sensor -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE REAR STEP COVER (w/ Sliding Roof) |
 |
- HINT:
- Use the same procedure to remove the step cover on the other side.
Detach the 2 claws and remove the step cover.
| 3. REMOVE REAR STEP COVER (w/o Sliding Roof) |
|
- HINT:
- Use the same procedure to remove the step cover on the other side.
Detach the 2 claws and remove the step cover.
| 4. REMOVE REAR DOOR SCUFF PLATE LH (w/ Sliding Roof) |
 |
Remove the screw.
Detach the 3 claws and 4 clips, and remove the scuff plate.
| 5. REMOVE REAR DOOR SCUFF PLATE LH (w/o Sliding Roof) |
|
Remove the screw.
Detach the 3 claws and 4 clips, and remove the scuff plate.
| 6. REMOVE REAR DOOR SCUFF PLATE RH (w/ Sliding Roof) |
- HINT:
- Use the same procedures described for the LH side.
| 7. REMOVE REAR DOOR SCUFF PLATE RH (w/o Sliding Roof) |
- HINT:
- Use the same procedures described for the LH side.
| 8. REMOVE REAR FLOOR AIRBAG SENSOR |
Fold back the floor carpet.
Detach the clip and claw, and remove the cover.
 |
Remove the bolt and sensor.
 |
Disconnect the connector.