Front Bumper (W/ Winch) Removal

Remove the 3 bolts and screw.

Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

Remove the 3 bolts and 2 screws.

Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

Put protective tape around the front bumper winch cover sub-assembly.

Using moulding remover A, detach the 2 claws.

Detach the 2 guides and remove the front bumper winch cover sub-assembly as shown in the illustration.

Remove the 7 clips and upper radiator support seal.

Put protective tape around the headlight cover LH.

Detach the 5 claws and remove the headlight cover LH.

Using a T30 "TORX" socket, remove the 3 screws.

HINT:

Use the same procedure for the other side.

Remove the 2 screws and 4 bolts.

Remove the 3 screws.

Remove the 3 clips.

Put protective tape around the front bumper cover.

HINT:

Use the same procedure for the other side.

Detach the 3 claws.

HINT:

Use the same procedure for the other side.

Remove the front bumper cover.

Disconnect the winch control wire connector.

w/ Fog Light:
Disconnect the No. 4 engine room wire connector.

w/ Multi-terrain Monitor:
Disconnect the connector.

w/ Dynamic Radar Cruise Control System:
Disconnect the connector.

Remove the 3 bolts and front bumper extension LH.

Remove the 2 screws.

Detach the 3 claws and remove the front bumper side support LH.

for Halogen Headlight:
(Click here)

for LED Headlight:
(Click here)

for Halogen Headlight and LED Headlight:
(Click here)

Remove the 3 bolts.

Detach the guide and remove the front bumper upper center retainer.