Remote Control Switch On-Vehicle Inspection

Put protective tape around the front bumper winch cover sub-assembly.

Using moulding remover A, detach the 2 claws.

Detach the 2 guides and remove the front bumper winch cover sub-assembly as shown in the illustration.

Connect the remote control switch connector.

Turn the ignition switch on (IG) and check that the power indicator light illuminates.

Press the remote control switch, and check that the winch operates.

NOTICE:

Be careful not to tighten or strain the winch wire.

Turn the ignition switch off.

Remove the 4 screws and cover.

Disconnect the motor relay connector.

Remove the 2 nuts.

Pull the bumper side winch control wire out of the bumper.

Connect the bumper side winch control wire connector to the vehicle side winch control wire connector.

Connect the bumper side winch control wire connector to the winch control switch connector.

Turn the ignition switch on (IG) and check that the overheat temperature indicator light illuminates and the buzzer sounds.

Turn the ignition switch off.

Disconnect the bumper side winch control wire connector from the winch control switch connector.

Disconnect the bumper side winch control wire connector from the vehicle side winch control wire connector.

Pass the bumper side winch control wire through the bumper.

Install the 2 nuts.

Connect the motor relay connector.

Install the cover with the 4 screws.

Attach the 2 guides to install the front bumper winch cover sub-assembly.

Attach the 2 claws.