Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
3Ur-Fe Engine Control. Land Cruiser. Urj200, 202 Grj200 Vdj200
Heated Oxygen Sensor -- Removal |
- CAUTION:
- The procedures should be performed by at least 2 people.
- Wear protective gloves when removing the exhaust pipe.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.
| 1. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 2 bolts and No. 2 engine under cover.
 |
| 2. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Disconnect the heated oxygen sensor connector.
Remove the bolt and disconnect the wire harness clamp bracket of the oxygen sensor from the transmission.
Remove the 2 nuts, front No. 2 exhaust pipe and gasket from the exhaust manifold LH.
| 3. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the heated oxygen sensor connector.
Remove the bolt and disconnect the wire harness clamp bracket of the oxygen sensor from the transmission.
Remove the 2 nuts, front exhaust pipe and gasket from the exhaust manifold RH.
| 4. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
Using SST, remove the sensor.
- SST
- 09224-00010
 |
| 5. REMOVE NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
Using SST, remove the sensor.
- SST
- 09224-00010