Heated Oxygen Sensor Installation

Temporarily install the sensor to the exhaust pipe by hand.

Using SST, tighten the sensor.

SST

09224-00010

Torque:

without SST:

44 N*m{449 kgf*cm, 32 ft.*lbf}

with SST:

40 N*m{408 kgf*cm, 30 ft.*lbf}

HINT:

1. Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
   
2. Make sure SST and the wrench are connected in a straight line.
   

Temporarily install the sensor to the exhaust pipe by hand.

Using SST, tighten the sensor.

SST

09224-00010

Torque:

without SST:

44 N*m{449 kgf*cm, 32 ft.*lbf}

with SST:

40 N*m{408 kgf*cm, 30 ft.*lbf}

HINT:

1. Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
   
2. Make sure SST and the wrench are connected in a straight line.
   

Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 2 new nuts.

Torque:

54 N*m{551 kgf*cm, 40 ft.*lbf}

Install the wire harness clamp bracket of the oxygen sensor to the transmission with the bolt.

Torque:

29 N*m{296 kgf*cm, 21 ft.*lbf}

Connect the heated oxygen sensor connector.

Install a new gasket and the front No. 2 exhaust pipe to the exhaust manifold LH with 2 new nuts.

Torque:

54 N*m{551 kgf*cm, 40 ft.*lbf}

Install the wire harness clamp bracket of the oxygen sensor to the transmission with the bolt.

Torque:

29 N*m{296 kgf*cm, 21 ft.*lbf}

Connect the heated oxygen sensor connector.

Install the No. 2 engine under cover with the 2 bolts.

Torque:

29 N*m{296 kgf*cm, 21 ft.*lbf}