Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
1Vd-Ftv Engine Mechanical. Land Cruiser. Urj200, 202 Grj200 Vdj200
Front Crankshaft Oil Seal -- Removal |
| 1. REMOVE RADIATOR ASSEMBLY |
| 2. REMOVE CRANKSHAFT PULLEY SUB-ASSEMBLY |
- NOTICE:
 |
- This procedure is intended for removal/installation of the crankshaft pulley only. Do not use this procedure for removal/installation of the flywheel or the drive plate and ring gear.
| *1 | Service Hole |
| *2 | Protrusion |
Install the 2 bolts to the bolt holes of the crankshaft rear side.
Using a bar, turn the crankshaft until the crankshaft pulley service hole is a little to the left of bottom dead center.
Install a 14 mm x 1.5 pitch service bolt with a length of 70 mm or more to the crankshaft pulley service hole, and hold the crankshaft using the timing chain cover protrusion.
Remove the 3 bolts and crankshaft pulley.
- NOTICE:
- If the crankshaft pulley cannot be removed, temporarily install a bolt to the crankshaft so that the pulley does not fall, and lightly tap the outer edge of the mass damper with a plastic-faced hammer to remove the pulley. Do not tap the pulley V-ribbed belt ribs, as the crankshaft may be damaged.
| 3. REMOVE FRONT CRANKSHAFT OIL SEAL |
Using a knife, cut off the lip of the oil seal.
Text in Illustration *1 Cut Position *2 Front Crankshaft Oil Seal
 |
Using a screwdriver, pry out the oil seal.
- NOTICE:
- Be careful not to damage the crankshaft.
- HINT:
- Tape the screwdriver tip before use.