Manifold Absolute Pressure Sensor On-Vehicle Inspection

Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
1Vd-Ftv Engine Control. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. CHECK DIESEL TURBO PRESSURE SENSOR

Manifold Absolute Pressure Sensor -- On-Vehicle Inspection



1. CHECK DIESEL TURBO PRESSURE SENSOR


Land Cruiser. Urj200, 202 Grj200 Vdj200.1Vd-Ftv Engine Control.Ecd System (W/ Dpf).Manifold Absolute Pressure Sensor On-Vehicle Inspection

  1. Inspect the power source voltage.

    1. Disconnect the sensor connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      		Switch Condition
      		Specified Condition
      C80-3 (VC) - C80-1 (E2)
      		Engine switch on (IG)
      		4.75 to 5.25 V

    3. Turn the engine switch off.

    4. Connect the sensor connector.

  1. Check the vacuum and pressure.

    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG) and turn the GTS on.

    3. Enter the following menus: Powertrain / Engine / Data List / Map and Atmosphere Pressure.

    4. Read the value.

      OK:
      Condition
      		Map and Atmosphere Pressure Value
      No pressure applied
      		Same as atmospheric pressure
      Vacuum applied
      		Becomes vacuum
      Pressure applied
      		Becomes pressurized
      If the result is not as specified, replace the sensor.