Transfer Oil On-Vehicle Inspection

Remove the filler plug and gasket.

Check that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
If the result is not as specified, add transfer oil.

Viscosity:

SAE 75W

Standard Capacity:

1.4 to 1.5 liters (1.5 to 1.6 US qts, 1.2 to 1.3 Imp. qts)

NOTICE:

Too much or too little oil will lead to transfer problems.

When the oil level is too low, check for oil leaks.

Install a new gasket onto the filler plug and then tighten the plug.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

Remove the filler plug and gasket.

Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

NOTICE:

1. Add oil slowly.
   
2. Add oil a little at a time, waiting several minutes between each addition of oil.
   

Wait approximately 5 minutes and check that the oil level has not changed.

Install a new gasket onto the filler plug and then tighten the plug.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}