Side Airbag Sensor Removal
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
REMOVE ASSIST GRIP COVER LH
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE SIDE AIRBAG SENSOR
Side Airbag Sensor -- Removal |
- HINT:
- Use the same procedures for the RH and LH.
- The procedures listed below are the LH side.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
Detach the clip and claw, and remove the front door lower frame bracket garnish LH.
| 3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH |
Using a screwdriver, detach the 4 claws and remove the front door inside handle bezel LH.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
| Protective Tape
|
| 4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY |
Using a moulding remover, detach the 5 claws.
Disconnect the connector and remove the armrest base panel.
| 5. REMOVE ASSIST GRIP COVER LH |
Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.
| 6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
Remove the 3 screws.
Remove the 13 clips.
Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.
- HINT:
- Make sure that the pin labeled A in the illustration is detached from the door panel.
Disconnect the each connector.
Disconnect the 2 cables from the front door inside handle sub-assembly LH.
| 7. REMOVE SIDE AIRBAG SENSOR |
Disconnect the connector.
Remove the bolt and side airbag sensor.
