Side Airbag Sensor Installation

Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Supplemental Restraint Systems. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. INSTALL SIDE AIRBAG SENSOR

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  3. INSTALL ASSIST GRIP COVER LH

  4. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

  5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

  6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  8. CHECK SRS WARNING LIGHT

Side Airbag Sensor -- Installation


HINT:
  1. Use the same procedures for the RH and LH.
  2. The procedures listed below are the LH side.


1. INSTALL SIDE AIRBAG SENSOR


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Install the side airbag sensor with the bolt.

    Torque:
    9.0 N*m{92 kgf*cm, 80 in.*lbf}
    NOTICE:
    1. If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the side airbag sensor.

  1. Connect the connector.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Connect the connector.

  1. Connect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH to the front door inside handle sub-assembly LH.



    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Attach the 4 claws and 13 clips to install the front door trim board sub-assembly LH.

  1. Install the 3 screws.



3. INSTALL ASSIST GRIP COVER LH

  1. Attach the 8 claws to install the door assist grip cover LH to the front door trim board sub-assembly LH.



4. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

  1. Connect the connector.



    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Attach the 5 claws to install the armrest base panel.



5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Attach the 4 claws to install the front door inside handle bezel LH.



6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

  1. Attach the clip and claw, and install the front door lower frame bracket garnish LH.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


8. CHECK SRS WARNING LIGHT

  1. Check the SRS warning light (Click here).