Power Window Regulator Motor (For Rear Door) Removal

Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Window Glass. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. PRECAUTION

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL

  4. REMOVE REAR DOOR UPPER ARMREST BASE PANEL

  5. REMOVE ASSIST GRIP COVER

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  7. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP

  8. REMOVE REAR SPEAKER SET (w/ Rear Speaker)

  9. REMOVE REAR DOOR SERVICE HOLE COVER

  10. REMOVE REAR DOOR GLASS RUN

  11. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

  12. REMOVE REAR DOOR QUARTER WINDOW GLASS

  13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

  14. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

  15. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

Power Window Regulator Motor (For Rear Door) -- Removal


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE REAR DOOR INSIDE HANDLE BEZEL


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Using a screwdriver, detach the 4 claws and remove the rear door inside handle bezel LH.

    HINT:
    Tape the screwdriver tip before use.
    Text in Illustration
    Land Cruiser. Urj200, 202 Grj200 Vdj200
    		Protective Tape


4. REMOVE REAR DOOR UPPER ARMREST BASE PANEL


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Using a moulding remover, detach the 7 claws.

  1. Disconnect the connector and remove the rear door upper armrest base panel assembly LH.



5. REMOVE ASSIST GRIP COVER


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Using a moulding remover, detach the 9 claws and remove the assist grip cover LH.



6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Window Glass.Power Window Control System (For Models With Jam Protection Function On 4 Windows).Power Window Regulator Motor (For Rear Door) Removal

  1. Remove the 3 screws.

  1. Remove the 9 clips.

  1. Remove the rear inner door glass weatherstrip LH together with the rear door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

    HINT:
    Make sure that the pin labeled A in the illustration is detached from the door panel.

  1. Disconnect the connector and remove the rear door trim board sub-assembly LH.



    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Disconnect the 2 cables from the rear door inside handle sub-assembly LH.



7. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Detach the 4 clips and remove the rear door inner glass weatherstrip LH from the rear door trim board sub-assembly LH.

    NOTICE:
    1. Squeeze the metal clip to remove it.
    2. The metal clip may be deformed if it is forcibly pulled.


8. REMOVE REAR SPEAKER SET (w/ Rear Speaker)


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Disconnect the speaker connector.

  1. Remove the 3 screws.

  1. Detach the claw and remove the speaker.

    NOTICE:
    Do not touch the cone part of the speaker.


9. REMOVE REAR DOOR SERVICE HOLE COVER


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Using a clip remover, detach the 7clamps.

  1. Remove the bolt and disconnect the 3connectors.

  1. Remove the rear door service hole cover LH.

    HINT:
    Remove the remaining tape on the door.


10. REMOVE REAR DOOR GLASS RUN


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Remove the rear door glass run LH from the window frame.



11. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Remove the 2 bolts.

  1. Remove the screw and rear door rear lower window frame sub-assembly LH.



12. REMOVE REAR DOOR QUARTER WINDOW GLASS


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Remove the rear door quarter window glass LH and rear door quarter window weatherstrip LH as a unit as shown in the illustration.



13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Remove the rear door glass sub-assembly LH from the rear door window regulator sub-assembly LH as shown in the illustration.

    NOTICE:
    Do not damage the door glass.


14. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Window Glass.Power Window Control System (For Models With Jam Protection Function On 4 Windows).Power Window Regulator Motor (For Rear Door) Removal

  1. Loosen the temporary bolt.

    NOTICE:
    Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator sub-assembly LH may fall and cause damage.
    Text in Illustration
    *a
    		Temporary Bolt

  1. Remove the 3 bolts and rear door window regulator sub-assembly LH.

    NOTICE:
    Be careful when removing the bolts as the motor may fall and become damaged.

  1. Remove the temporary bolt from the rear door window regulator sub-assembly LH.



15. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Window Glass.Power Window Control System (For Models With Jam Protection Function On 4 Windows).Power Window Regulator Motor (For Rear Door) Removal

  1. Using a T25 "TORX" driver, remove the 3 screws and motor.

    NOTICE:
    Be careful when removing the screws as the motor may fall and become damaged.
    Text in Illustration
    *a
    		for Models with Jam Protection Function on 4 Windows
    *b
    		for Models with Jam Protection Function on Driver Door Window Only