Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
1Vd-Ftv Lubrication. Land Cruiser. Urj200, 202 Grj200 Vdj200
Oil Pressure Sensor -- Removal |
| 1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
Remove the 3 bolts and screw.
 |
Loosen the clip and remove the front fender splash shield LH.
| 2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
Remove the 3 bolts and 2 screws.
Loosen the clip and remove the front fender splash shield RH.
| 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 10 bolts and No. 1 engine under cover.
 |
| 4. DRAIN ENGINE OIL |
Remove the 2 bolts and No. 2 engine under cover seal from the No. 2 engine under cover.
 |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
- Torque:
- 38 N*m{387 kgf*cm, 28 ft.*lbf}
| 5. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY |
Disconnect the oil pressure sender gauge connector.
 |
Remove the oil pressure sender gauge.