Wiper And Washer System (W/ Rain Sensor) Data List / Active Test

Vehicle Exterior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Wiper Washer. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. DATA LIST

  1. ACTIVE TEST

Wiper And Washer System (W/ Rain Sensor) -- Data List / Active Test



DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Body No. 4/ Data List.

  5. Read the Data List according to the display on the GTS.

    Body No. 4
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Rear Wiper Switch*
    		Status of the Rear Wiper Switch /OFF or ON
    		ON: Rear wiper switch on
    OFF: Rear wiper switch off
    		-
    Rear Wiper Int Switch*
    		Status of the Rear Wiper Int Switch /OFF or ON
    		ON: except Rear wiper switch off
    OFF: Rear wiper switch off
    		-
    Rear Wiper Lo Switch*
    		Status of the Rear Wiper Lo Switch /OFF or ON
    		ON: Rear wiper switch Lo
    OFF: except Rear wiper switch Lo
    		-
    Rear Washer Switch*
    		Status of the Rear Washer Switch /OFF or ON
    		ON: Rear washer switch on
    OFF: Rear washer switch off
    		-
    Front Wiper Motor Position Detection*
    		Status of the Front Wiper Motor Position Detection /Stop Position or Not Stop Position
    		Stop Position: Front wiper motor stop position
    Not Stop Position: Front wiper motor not stop position
    		-
    Front Washer Nozzle Heater
    		Status of the Front Washer Nozzle Heater /OFF or ON
    		ON: Front washer nozzle heater on
    OFF: Front washer nozzle heater off
    		w/ Front washer nozzle heater
    *: Although the item is displayed on the GTS, it is not applicable to this vehicle.


ACTIVE TEST
HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Body No. 4 / Active Test.

  5. According to the display on the GTS, perform the Active Test.


Body No. 4
Tester Display
Test Part
Control Range
Diagnostic Note
Rear Wiper Lo*
Rear wiper motor assembly lo operation
OFF/ON
-
Front Washer Nozzle Heater
Washer nozzle heater operation
ON / OFF
-
*: Although the item is displayed on the GTS, it is not applicable to this vehicle.