Side Turn Signal Light Assembly (For Outer Rear View Mirror) -- Installation |
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH |
Connect the connector.
Install the light with the 3 screws.
| 2. INSTALL OUTER MIRROR COVER LH |
Install the outer mirror cover LH.
Insert the rib on the outer edge of the cover into the groove of the mirror body.
- NOTICE:
- Do not scratch the turn light.
Text in Illustration *1 Rib Confirm that the cover and mirror body are aligned properly, and then push the outer end of the cover to attach the outer claws.
- NOTICE:
- Make sure that the upper ribs of the cover shown in part A of the illustration are properly attached to the mirror body.
- Make sure that the ribs of the mirror body shown in part B of the illustration are not protruding from the cover.
Text in Illustration *1 Rib While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.
Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.
 |
Check that there is no gap between the cover and mirror body.
- HINT:
- If there is a gap between the cover and body, noise will occur during driving.
| 3. INSTALL OUTER MIRROR LH |
w/ Blind Spot Monitor System:
Connect the connector.
 |
w/ EC Mirror:
Connect the connector.
 |
w/ Mirror Heater:
Connect the 2 connectors.
 |
Attach the 4 claws to install the outer mirror LH.
 |
| 4. INSTALL OUTER REAR VIEW MIRROR LH |