Dtc B1242 Wireless Door Lock Tuner Circuit Malfunction

Vehicle Interior. Land Cruiser. Urj200, 202 Grj200 Vdj200
Door Lock. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CLEAR DTC

CHECK FOR DTC

CHECK DOOR CONTROL RECEIVER (DOOR CONTROL RECEIVER - MAIN BODY ECU)

CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)

REPLACE DOOR CONTROL RECEIVER

CLEAR DTC

CHECK FOR DTC

DTC B1242 Wireless Door Lock Tuner Circuit Malfunction


DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is stored when the applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.

DTC Code
DTC Detection Condition
Trouble Area
B1242
The applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.
  1. Harness or connector
  2. Door control receiver
  3. Main body ECU (Cowl Side Junction Block LH)

WIRING DIAGRAM


Land Cruiser. Urj200, 202 Grj200 Vdj200.Door Lock.Power Door Lock Control System. Dtc B1242 Wireless Door Lock Tuner Circuit Malfunction


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. When replacing the door control receiver, refer to the registration procedures (Click here).
1.CLEAR DTC

  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC

  1. Check for DTCs (Click here).

    OK:
    DTC B1242 is not output.


NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)

3.CHECK DOOR CONTROL RECEIVER (DOOR CONTROL RECEIVER - MAIN BODY ECU)

  1. Disconnect the L47 receiver connector.

  1. Disconnect the E2 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    L47-2 (RDA) - E2-12 (RDA)
    		Always
    		Below 1 Ω
    L47-3 (PRG) - E2-10 (PRG)
    		Always
    		Below 1 Ω
    L47-2 (RDA) - Body ground
    		Always
    		10 kΩ or higher
    L47-3 (PRG) - Body ground
    		Always
    		10 kΩ or higher


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Door Lock.Power Door Lock Control System. Dtc B1242 Wireless Door Lock Tuner Circuit Malfunction

  1. Disconnect the L47 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    L47-1 (GND) - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Condition
    		Specified Condition
    L47-5 (+B) - Body ground
    		Always
    		11 to 14 V
    Text in Illustration
    *a
    		Front view of wire harness connector
    (to Door Control Receiver)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE DOOR CONTROL RECEIVER

  1. Temporarily replace the door control receiver with a new one (Click here).

  1. Perform the registration procedures (Click here).


NEXT


6.CLEAR DTC

  1. Clear the DTCs (Click here).


NEXT


7.CHECK FOR DTC

  1. Check for DTCs (Click here).

    OK:
    DTC B1242 is not output.


NG
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
OK

END (DOOR CONTROL RECEIVER IS DEFECTIVE)