Transfer Assembly Installation

Install the transfer with the 8 bolts.

Torque:

40 N*m{408 kgf*cm, 30 ft.*lbf}

NOTICE:

Take care not to damage the adaptor oil seal with the transfer input shaft spline.

for 1VD-FTV:
(Click here)

for 1UR-FE:
(Click here)

for 3UR-FE:
(Click here)

Install a new gasket onto the drain plug and then install the plug.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

NOTICE:

1. Add oil slowly.
   
2. Add oil a little at a time, waiting several minutes between each addition of oil.
   

Wait approximately 5 minutes and check that the oil level has not changed.

Install a new gasket onto the filler plug and then install the plug.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

Install the lower transfer case protector with the 7 bolts.

Torque:

14 N*m{139 kgf*cm, 10 ft.*lbf}

Install the transfer heat insulator with the 4 bolts.

Torque:

30 N*m{306 kgf*cm, 22 ft.*lbf}

except 1GR-FE:
Install the transfer dynamic damper with the 2 bolts.

Torque:

12 N*m{122 kgf*cm, 9 ft.*lbf}