Brake. Land Cruiser. Urj200, 202 Grj200 Vdj200
Brake Control Dynamic Control Systems. Land Cruiser. Urj200, 202 Grj200 Vdj200
Rear Speed Sensor -- Installation |
| 1. INSTALL REAR SPEED SENSOR LH |
Install the speed sensor with the nut.
- Torque:
- 8.3 N*m{85 kgf*cm, 73 in.*lbf}
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- Make sure there is no foreign matter attached to the speed sensor rotor.
 |
| 2. INSTALL REAR SPEED SENSOR RH |
Install the speed sensor with the nut.
- Torque:
- 8.3 N*m{85 kgf*cm, 73 in.*lbf}
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- Make sure there is no foreign matter attached to the speed sensor rotor.
 |
| 3. INSTALL SKID CONTROL SENSOR WIRE |
Install the sensor clamp with the bolt.
- Torque:
- 13 N*m{127 kgf*cm, 9 ft.*lbf}
- NOTICE:
- Make sure the clamp rotation stopper touches the installation position.
 |
Connect the connector.
- NOTICE:
- Securely insert the connector.
- When connecting the connector, do not twist the wire harness.
Install the sensor clamp with the bolt.
- Torque:
- 13 N*m{127 kgf*cm, 9 ft.*lbf}
- NOTICE:
- Make sure the clamp rotation stopper touches the installation position.
 |
Connect the speed sensor RH connector.
- NOTICE:
- Securely connect the connector.
- When connecting the connector, do not twist the wire harness.
 |
Attach the 3 clamps.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
- When attaching the clamps, securely insert them as shown in the illustration.
Attach the 5 clamps.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
- When attaching the clamps, securely insert them as shown in the illustration.
Attach the 2 clamps, and install the sensor clamp with the bolt.
- Torque:
- 13 N*m{127 kgf*cm, 9 ft.*lbf}
Connect the speed sensor LH connector.
- NOTICE:
- Securely connect the connector.
- When connecting the connector, do not twist the wire harness.
 |
| 4. INSTALL REAR WHEEL |
- Torque:
- for Aluminum Wheel:
- 131 N*m{1336 kgf*cm, 97 ft.*lbf}
- for Steel Wheel:
- 209 N*m{2131 kgf*cm, 154 ft.*lbf}
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 6. CHECK SPEED SENSOR SIGNAL |
w/ ABS:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).