Audio And Visual System (W/O Navigation System) Stereo Component Amplifier Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
AUDIO AND VISUAL SYSTEM (w/o Navigation System) - Stereo Component Amplifier Power Source Circuit |
DESCRIPTION
This circuit provides power to the stereo component amplifier assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY |
Disconnect the F2 and F18 stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
F2-2 (GND) - Body ground
| Always
| Below 1 Ω
|
F2-6 (GND2) - Body ground
| Always
| Below 1 Ω
|
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
F2-3 (+B2) - F2-2 (GND)
| Always
| 11 to 14 V
|
F18-12 (ACC) - F2-2 (GND)
| Engine switch on (ACC)
| 11 to 14 V
|
Text in Illustration*1
| Front view of wire harness connector
(to Stereo Component Amplifier Assembly)
|
*2
| Front view of wire harness connector
(to Stereo Component Amplifier Assembly)
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
|
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here) |
|
