Dtc C1433 Steering Angle Sensor Internal Circuit
Brake. Land Cruiser. Urj200, 202 Grj200 Vdj200
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
DTC C1433 Steering Angle Sensor Internal Circuit |
DESCRIPTION
Steering angle sensor signals are sent to the skid control ECU (master cylinder solenoid) via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor zero point malfunction diagnostic function.DTC Code
| DTC Detection Condition
| Trouble Area
|
C1433
| Either condition is met:
- With the IG1 terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor for 0.012 seconds.
- An open in the sensor power supply circuit for 1 second or more.
| Steering angle sensor (Spiral with sensor cable sub-assembly)
|
WIRING DIAGRAM
Refer to DTC C1432 (Click here).
INSPECTION PROCEDURE
- HINT:
- When any of the speed sensors or the yaw rate and acceleration sensor (airbag sensor assembly) has trouble, DTCs for the steering angle sensor (spiral with sensor cable sub-assembly) may be stored even when the steering angle sensor (spiral with sensor cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag sensor assembly) are output together with DTCs for the steering angle sensor (spiral with sensor cable sub-assembly), inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag sensor assembly) first, and then inspect and repair the steering angle sensor (spiral with sensor cable sub-assembly).
| 1.REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY |
Replace the steering angle sensor (spiral with sensor cable sub-assembly) (Click here).
- NOTICE:
- Do not remove the steering angle sensor from the spiral with sensor cable sub-assembly.
- When replacing the spiral with sensor cable sub-assembly, confirm that the replacement part is of the correct specification.