Dynamic Radar Cruise Control System Millimeter Wave Radar Sensor Power Source Circuit

Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
Cruise Control. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY (IGB VOLTAGE)

CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)

DYNAMIC RADAR CRUISE CONTROL SYSTEM - Millimeter Wave Radar Sensor Power Source Circuit


DESCRIPTION

When the engine switch is turned on (IG), battery voltage is applied to terminal IGB of the millimeter wave radar sensor assembly.
This circuit provides power to the millimeter wave radar sensor assembly. The millimeter wave radar sensor assembly emits radio waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front. This data is transmitted to the driving support ECU assembly.

WIRING DIAGRAM


Land Cruiser. Urj200, 202 Grj200 Vdj200.Cruise Control.Cruise Control System.Dynamic Radar Cruise Control System  Millimeter Wave Radar Sensor Power Source Circuit


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1.CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY (IGB VOLTAGE)


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Cruise Control.Cruise Control System.Dynamic Radar Cruise Control System  Millimeter Wave Radar Sensor Power Source Circuit
  1. Disconnect the millimeter wave radar sensor assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A72-8 (IGB) - Body ground
    Engine switch on (IG)
    11 to 14 V
    Text in Illustration
    *a
    Front view of wire harness connector
    (to Millimeter Wave Radar Sensor Assembly)


NG
REPAIR OR REPLACE POWER SOURCE CIRCUIT
OK


2.CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)
  1. Disconnect the A72 millimeter wave radar sensor assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    A72-1 (SGND) - Body ground
    Always
    Below 1 Ω


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)