Automatic Transmission System (For 1Ur-Fe) Monitor Drive Pattern

Drivetrain. Land Cruiser. Urj200, 202 Grj200 Vdj200
Ab60F Automatic Transmission Transaxle. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. TEST MONITOR DRIVE PATTERN FOR ECT

Automatic Transmission System (For 1Ur-Fe) -- Monitor Drive Pattern



TEST MONITOR DRIVE PATTERN FOR ECT
CAUTION:
Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.
HINT:
Performing this drive pattern is one method to simulate the malfunction detection conditions of the ECT.
The DTCs may not be stored through ordinary, everyday driving. Also, DTCs may not be stored through this drive pattern.

  1. Preparation for driving

    1. Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).

    2. Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.
      Malfunctions are not detected when the atmospheric temperature is less than -10°C (14°F).

  2. Drive pattern

    1. Drive the vehicle through all the gears.
      Stop → 1st → 2nd → 3rd → 4th → 5th → 5th (lock-up ON) → 6th → 6th (lock-up ON).

    2. Repeat the above drive pattern 3 times or more.

      NOTICE:
      1. When using the GTS, the monitor status can be checked in the Data List (Click here).
      2. In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

Land Cruiser. Urj200, 202 Grj200 Vdj200.Ab60F Automatic Transmission Transaxle.Automatic Transmission System (For 1Ur-Fe).Automatic Transmission System (For 1Ur-Fe) Monitor Drive Pattern

HINT:
*: Drive at such a speed in the uppermost gear so as to engage lock-up. The vehicle can be driven at a speed lower than the speed shown in the above diagram in lock-up.
NOTICE:
It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P0711 (No. 1 ATF temperature sensor malfunction).