Ecd System (W/O Dpf) Check Mode Procedure

Engine Hybrid System. Land Cruiser. Urj200, 202 Grj200 Vdj200
1Vd-Ftv Engine Control. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. CHECK MODE PROCEDURE (Using Intelligent Tester)

Ecd System (W/O Dpf) -- Check Mode Procedure


HINT:
Intelligent tester only:
Compared to the normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.
NOTICE:
All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.

CHECK MODE PROCEDURE (Using Intelligent Tester)

  1. Check and ensure the following conditions:

    1. Battery positive voltage 11 V or higher.

    2. Throttle valve fully closed.

    3. Transmission in neutral.

    4. A/C switched off.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the tester on.

  6. Enter the following menus: Utility / Check Mode.

  7. Switch the ECM from normal mode to check mode.



    8. Land Cruiser. Urj200, 202 Grj200 Vdj200.1Vd-Ftv Engine Control.Ecd System (W/ Dpf).Ecd System (W/O Dpf) Check Mode Procedure

  8. Make sure the MIL flashes as shown in the illustration.

  9. Start the engine.

  10. Make sure the MIL turns off.

  11. Simulate the conditions of the malfunction described by the customer.

  12. Check for DTCs and freeze frame data using the tester.

  13. After checking for DTCs, inspect the applicable circuits.