Dtc C1417 High Power Supply Voltage Malfunction

Brake. Yaris. Ncp93, 131
Brake Control Dynamic Control Systems. Yaris. Ncp93, 131

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

INSPECT BATTERY

CHECK TERMINAL VOLTAGE (IG1 TERMINAL)

RECONFIRM DTC

DTC C1417 High Power Supply Voltage Malfunction


DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.
The DTC is cancelled when the IG1 terminal voltage returns to normal.

DTC No.
DTC Detection Condition
Trouble Area
C1417
The IG1 terminal voltage is 17.4 V or more for 0.8 seconds or more.
  1. Battery
  2. Charging system
  3. Power source circuit
  4. Internal power supply circuit of the skid control ECU

WIRING DIAGRAM

Refer to DTC C1241 (YARIS_NCP93 RM000000XW60CDX.html).

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1.INSPECT BATTERY

  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V


NG
CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (YARIS_NCP93 RM000001GNJ010X.html)
OK


2.CHECK TERMINAL VOLTAGE (IG1 TERMINAL)

  1. Disconnect the skid control ECU (brake actuator assembly) connector.

  1. Turn the ignition switch to ON.



    Yaris. Ncp93, 131.Brake Control Dynamic Control Systems.Anti-Lock Brake System (For Sedan). Dtc C1417 High Power Supply Voltage Malfunction

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Switch Condition
    		Specified Condition
    A71-34 (IG1) - Body ground
    		Ignition switch ON
    		11 to 14 V
    Text in Illustration
    *a
    		Front view of wire harness connector
    (to Skid control ECU)

  1. Turn the ignition switch off.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)
OK


3.RECONFIRM DTC

  1. Clear the DTCs (YARIS_NCP93 RM000000XHV0CPX.html).

  1. Check if the same DTC is recorded (YARIS_NCP93 RM000000XHV0CPX.html).

Result
Result
Proceed to
DTC C1417 is not output
A
DTC C1417 is output
B


B
REPLACE BRAKE ACTUATOR ASSEMBLY (YARIS_NCP93 RM000001BXP02KX.html)
A

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (YARIS_NCP93 RM000000XHS0AMX.html)