Starter (For Sedan For Cold Area Specification Vehicles) Disassembly
REMOVE MAGNET SWITCH BODY
REMOVE STARTER YOKE ASSEMBLY
REMOVE STARTER COMMUTATOR END FRAME COVER
REMOVE STARTER ARMATURE ASSEMBLY
REMOVE STARTER ARMATURE PLATE
REMOVE STARTER PLANETARY GEAR
REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
Starter (For Sedan For Cold Area Specification Vehicles) -- Disassembly |
| 1. REMOVE MAGNET SWITCH BODY |
Remove the nut, and disconnect the lead wire from the magnet switch body.
Remove the 2 screws holding the magnet switch body onto the starter drive housing assembly.
Remove the magnet switch body.
Remove the return spring and the plunger.
| 2. REMOVE STARTER YOKE ASSEMBLY |
Remove the 2 through bolts, and pull out the starter yoke assembly and starter commutator end frame assembly together.
Remove the starter yoke assembly from the starter commutator end frame assembly.
| 3. REMOVE STARTER COMMUTATOR END FRAME COVER |
Using a screwdriver, remove the starter commutator end frame cover.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
Using snap ring pliers, remove the snap ring and the plate washer.
Remove the starter armature assembly from the commutator end frame assembly.
| 5. REMOVE STARTER ARMATURE PLATE |
Remove the starter armature plate from the starter yoke assembly.
| 6. REMOVE STARTER PLANETARY GEAR |
Remove the 3 planetary gears.
| 7. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
Remove the starter center bearing clutch sub-assembly with drive lever set pin from the starter drive housing assembly.
Remove the drive lever set pin from the starter center bearing clutch sub-assembly.
