Upper Instrument Panel (For Sedan) Installation

Using a nipper, cut off both ends of the runner portion shown in the illustration (When installing a new one).

Engage the 5 claws at the front side of the instrument panel.

Engage the 7 clips at the rear side of the instrument panel.

Install the upper instrument panel with the 2 <C> bolts and the 2 <B> screws.

Torque:

20 N*m{204 kgf*cm, 15 ft.*lbf} for bolt <C>

Connect the passenger airbag connector and clamp.

Engage the claws of the hinge portions by pushing the glove compartment door in the horizontal direction to install the glove compartment door assembly.

NOTICE:

Engage the claw by pushing it in the horizontal direction, otherwise, installation failure caused by excessive play around the hinge portion will result.

Slightly flex the upper portion of the glove compartment door assembly to engage the stopper.

Install the 2 glove compartment door stoppers onto the glove compartment door.

w/ Curtain Shield Airbag:

1. Remove the piece of cloth or nylon.
   

Install the 3 clamps.

Connect the antenna connector.

w/ Curtain Shield Airbag:

1. Install 2 new special clips and the clip onto the front pillar garnish.
   

2. Engage the 2 clips and the 2 claws and install the front pillar garnish.
   

w/o Curtain Shield Airbag:

1. Engage the 2 clips and the 2 claws and install the front pillar garnish.
   

w/ Curtain Shield Airbag:

1. Remove the piece of cloth or nylon.
   

Install the 4 clamps.

w/ Curtain Shield Airbag:

1. Install 2 new special clips and the clip onto the front pillar garnish.
   

2. Engage the 2 clips and the 2 claws and install the front pillar garnish.
   

w/o Curtain Shield Airbag:

1. Engage the 2 clips and the 2 claws and install the front pillar garnish.
   

Install the front door opening trim weatherstrip.

Install the front door opening trim weatherstrip.

Install the combination meter assembly with the 2 screws.

NOTICE:

Install the meter by inserting the ribbed portions of the meter between the instrument panel and meter cluster.

Connect the 2 connectors.

Fit the 2 claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.

Engage the 5 claws and 5 clips and install the instrument cluster finish panel.

Engage the 6 claws and 3 clips and install the instrument panel finish panel end RH.

Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.

Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.