Transmission Control Cable (For Sedan) -- Removal |
1. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
Remove the shift lever knob.
![]() |
3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
Shift the shift lever into the N position.
![]() |
Disengage the 5 clips and the claw and remove the upper console panel.
4. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY |
Disengage the 3 clips and 3 claws.
![]() |
Disconnect the connector and remove the console upper rear panel.
5. REMOVE CONSOLE BOX CARPET |
![]() |
Remove the console box carpet.
6. REMOVE REAR CONSOLE BOX ASSEMBLY |
Disconnect the clamp.
![]() |
Remove the 2 bolts and 2 screws.
Disengage the 4 claws and remove the rear console box.
7. DISCONNECT OXYGEN SENSOR CONNECTOR |
8. REMOVE EXHAUST PIPE ASSEMBLY FRONT |
Remove the 2 bolts and 2 compression springs.
Remove 3 No. 4 exhaust pipe support and the front exhaust pipe assembly.
Remove the 2 exhaust pipe gaskets.
9. REMOVE FRONT FLOOR HEAT INSULATOR NO.1 |
Remove the 2 bolts and nut and remove floor heat insulator No.1.
10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
*1 | Select Cable |
*2 | Shift Cable |
*3 | Clip |
*4 | Stopper |
*5 | Nut |
*6 | Shift Lever Retainer. |
*a | Rotate 180° |
Disconnect the control shift cable from the shift lever.
Remove the clip and disconnect the control select cable from the shift lever.
Using a screwdriver, pull out the stopper of the transmission control cable.
- NOTICE:
- Do not remove the stopper. If it is removed, reinstall it to its original position.
Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.
- NOTICE:
- Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable will not be reusable.
Remove the 2 clips and the 2 washers, and disconnect the 2 cables from the transaxle.
![]() |
Remove the 2 clips and disconnect the 2 cables from the control cable bracket.
Remove the 3 nuts and remove the transmission control cable.
![]() |