Shift Lever Assembly (For Sedan) Installation

Install the shift lever with the 4 bolts.

Torque:

12 N*m{122 kgf*cm, 8.9 ft.*lbf}

Install the control shift cable onto the shift lever retainer.

Install the control select cable onto the shift lever retainer.

NOTICE:

1. Install the cable with the protruding portion of the cable outer facing upward.
   
2. After installing, check that the lock of the cable outer is protruding beyond portion A, as shown in the illustration.
   

Connect the control shift cable to the shift lever.

Install the control select cable onto the shift lever retainer.

NOTICE:

1. Install the cable with the protruding portion of the cable outer facing upward.
   
2. After installing, check that the lock of the cable outer is protruding beyond portion A, as shown in the illustration.
   

Connect the control select cable to the shift lever.

NOTICE:

1. Connect the control select cable so that the adjusting mechanism lock of the control select cable is installed on the left side of the vehicle.
   
2. Insert the clip in the direction shown in the illustration.
   

Remove the console box assembly (YARIS_NCP93 RM000001ZQU00DX_01_0005.html).

Remove the clip and disconnect the control select cable from the shift lever assembly.

Adjust the length of the control select cable.

1. Slide the adjuster case cover in the direction shown in the illustration (Illustration A).
   

2. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
   

3. Press the lock piece into the adjuster case and lock it (Illustration B).
   

4. Slide the cover in the direction shown in the illustration (Illustration C).
   

   NOTICE:

   Slide the cover past the protrusion portion of the lock piece (Illustration D).

Install the clip to the shift lever assembly.

Install the console box assembly (YARIS_NCP93 RM000001ZQS00DX_01_0001.html).

Engage the 4 claws and install the rear console box.

Install the 2 bolts and 2 screws.

Connect the clamp.

Install the console box carpet.

Connect the connector.

Engage the 3 clips and 3 claws and install the console upper rear panel.

Engage the 5 clips and the claw and install the upper console panel.

Install the shift lever knob.

Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.