Tire Pressure Warning System (For Sedan) Precaution

Suspension. Yaris. Ncp93, 131
Tire Pressure Monitoring. Yaris. Ncp93, 131

  1. TIRE PRESSURE WARNING SYSTEM PRECAUTION

  1. IN CASE OF TIRE AND WHEEL REPLACEMENT

  1. FAIL-SAFE FUNCTION

  1. CHECK TIRE PRESSURE AFTER REPAIRS

Tire Pressure Warning System (For Sedan) -- Precaution



1.TIRE PRESSURE WARNING SYSTEM PRECAUTION


    Yaris. Ncp93, 131.Tire Pressure Monitoring.Tire Pressure Warning System (For Sedan).Tire Pressure Warning System (For Sedan) Precaution

  1. When the tire pressure warning light turns on, immediately check the tire pressures and adjust them to the specified value. (The tire pressure warning light will come on after blinking for 1 minute if there is an open in the tire pressure warning light circuit.)

    Cold Tire Inflation Pressure:

    Tire Size
    		Vehicle Speed
    		Front
    kPa (kgf/cm2, psi)
    		Rear
    kPa (kgf/cm2, psi)
    P175/65R14 81S
    P185/60R15 84T
    		Driving below 160 km/h (100 mph)
    		220 (2.2, 32)
    		220 (2.2, 32)
    Driving over 160 km/h (100 mph)
    		240 (2.4, 35)
    		240 (2.4, 35)

  2. When the tire pressure warning light turns on after blinking for 1 minute, there is a malfunction in the system. Check for DTCs.

  3. It is necessary to register the transmitter ID in the tire pressure warning ECU after replacing the tire pressure warning valve and transmitter and/or tire pressure warning ECU (YARIS_NCP93 RM000000XN107JX.html).

  4. When replacing the tire pressure warning ECU:

    1. Using the Data List, read the transmitter IDs registered in the ECU and make a note of them before removing the tire pressure warning ECU.

    2. Register the transmitter IDs after installing a new tire pressure warning ECU.



  5. When replacing the tire pressure warning valve and transmitter:



    1. Take a note of the 7 digit number (transmitter ID) written on the new tire pressure warning valve and transmitter when replacing the old one. Register the transmitter ID in the tire pressure warning ECU after replacing the tire pressure warning valve and transmitter and installing the tires and wheels on the vehicle.


      Yaris. Ncp93, 131.Tire Pressure Monitoring.Tire Pressure Warning System (For Sedan).Tire Pressure Warning System (For Sedan) Precaution

      NOTICE:
      The transmitter ID is written on the tire pressure warning valve and transmitter. It will be unable to be read after installing the tire pressure warning valve and transmitter on the tire and wheel. Therefore, take a note of the transmitter ID before installing the tire pressure warning valve and transmitter.

  6. Precautions about the tire pressure:

    1. The tire pressure decreases naturally.
    2. In winter, tire pressure may decrease due to low ambient temperatures (tire pressure decreases by approximately 10 kPa (0.1 kgf/cm2, 1.45 psi) for every 10°C (50°F) drop in the ambient temperature). Therefore, the tire pressure warning is more likely to operate if the tire pressures are not adjusted appropriately. If the daily temperature variation is large, pressurize the tires high so that the tire pressures are suitable under cold conditions. As a result, incorrect tire pressure warning operation should decrease.

2.IN CASE OF TIRE AND WHEEL REPLACEMENT

  1. When tires and wheels are replaced, always ensure that each transmitter ID is correctly registered.


3.FAIL-SAFE FUNCTION

  1. When a system malfunction occurs in the tire pressure warning system, the tire pressure warning light comes on after blinking for 1 minute and informs the driver of the system failure.

  2. The result of this diagnosis is stored in the tire pressure warning ECU.


4.CHECK TIRE PRESSURE AFTER REPAIRS

  1. After repairs, confirm that the actual tire pressures are displayed in the Data List (YARIS_NCP93 RM000000XMY06EX.html).