Vehicle Interior. Yaris. Ncp93, 131
Supplemental Restraint Systems. Yaris. Ncp93, 131
Steering Pad (For Hatchback) -- Removal |
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (YARIS_NCP93 RM000000KT10EAX.html).
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (YARIS_NCP93 RM00000482M008X.html).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| 3. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
 |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the lower No. 2 steering wheel cover.
Text in Illustration *1 Protective Tape
| 4. REMOVE STEERING PAD |
 |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Using a "TORX" driver, push in the 3 snap rings to disengage it from the 3 pins.
- NOTICE:
- Lightly hold the steering pad to prevent it from falling.
Pull the steering pad toward rear.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
Using a screwdriver with its tip wrapped with protective tape, release the 2 locking buttons.
Disconnect the 2 airbag connectors.
- NOTICE:
- When disconnecting the airbag connector, take care not to damage the airbag wire harness.
Text in Illustration *1 Protective Tape *2 Locking button
 |
Disconnect the horn terminal.