REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
Quarter Trim Speaker (For Hatchback) -- Removal |
- HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the RH side.
| 1. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |
| 2. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 3. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 4. REMOVE FRONT DOOR SCUFF PLATE |
Disengage the 8 claws and remove the front door scuff plate.
 |
| 5. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP |
Separate the front door opening trim weatherstrip.
| 6. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY |
Disengage the 2 claws and remove the anchor cover.
 |
Remove the bolt and separate the front seat outer belt.
 |
| 7. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY |
Disengage the 8 clips and 10 claws.
 |
Disengage the 3 guides and remove the quarter trim panel.
| 8. REMOVE REAR SPEAKER ASSEMBLY |
Disconnect the connector.
 |
Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the quarter panel.
 |
Operate the drill around the rivet head circumference and cut out the flange.
- CAUTION:
- Be careful. The cut rivet is very hot.
- NOTICE:
- Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.
After drilling out the flange, continue drilling to push out the shards on the drill.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the quarter panel.