Shift Lever Assembly (For Hatchback) Installation

Install the floor shift shift lever assembly with the 4 bolts.

Torque:

12 N*m{122 kgf*cm, 9 ft.*lbf}

Install the wire harness to the floor shift shift lever assembly with the 2 clamps.

Rotate the transmission control cable nut counterclockwise 180° and push in the lock while holding the nut.

Install the transmission control cable's cable outer onto the shift lever plate.

NOTICE:

After installation, check that the cable outer lock extends past the line A-A, as shown in the diagram.

Install the control shift cable to the shift lever assembly with the clip B.

Install the control select cable to the shift lever assembly with the clip A.

NOTICE:

Install the cable end adjustment mechanism so that the lock faces the driver seat.

Remove the clip and disconnect the control select cable from the floor shift shift lever assembly.

Slide the adjuster case cover in the direction shown in the illustration.

Pull out the lock piece from the adjuster case.

Install the control select cable to the floor shift shift lever assembly with the clip.

NOTICE:

1. Make sure to adjust the length at the neutral shift position.
   
2. Make sure that the lock piece is protruding from the adjuster case.
   

Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

Press the lock piece into the adjuster case and lock it.

Slide the adjuster case cover in the direction shown in the illustration.

NOTICE:

Slide the cover past the protrusion portion of the lock piece.