Steering Angle Sensor (For Sedan) Removal
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE STEERING PAD
REMOVE STEERING WHEEL ASSEMBLY
REMOVE STEERING COLUMN COVER
REMOVE SPIRAL CABLE
REMOVE STEERING SENSOR
Steering Angle Sensor (For Sedan) -- Removal |
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (YARIS_NCP93 RM000000KT10D1X.html).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Using "Torx" socket wrench T30, loosen the 2 bolts completely.
Pull the steering pad toward you.
Using a thin-bladed screwdriver, release the locking button.
Using a thin-bladed screwdriver, disconnect the 2 connectors.
Detach the horn terminal.
| 3. REMOVE STEERING WHEEL ASSEMBLY |
Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.
Using SST, remove the steering wheel assembly.
- NOTICE:
- Apply a small amount of grease to the threads and tip of the SST center bolt before using.
| 4. REMOVE STEERING COLUMN COVER |
Remove the 3 screws, disengage the 2 claws, release the tilt lever and remove the steering column lower cover.
Disengage the claw and remove the steering column upper cover.
Detach the horn connector.
Slide the slider and detach the airbag connector.
Detach the steering sensor connector.
Disengage the 3 claws and remove the spiral cable.
| 6. REMOVE STEERING SENSOR |
Disengage the 6 claws, and remove the steering sensor from the spiral cable.
