Transfer Oil On-Vehicle Inspection

Remove the transfer case plug No. 2 (for filler) and gasket.

Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
If the result is not as specified, add transfer oil.

Oil grade:

Hypoid gear oil SX API GL-5 or equivalent

Viscosity:

SAE 85W-90

Standard capacity:

0.45 liter (0.48 US qts, 0.40 Imp. qts)

NOTICE:

1. When adding oil, pour it slowly.
   
2. Too much or too little oil will lead to transfer problems.
   

When the oil level is too low, check for oil leakage.

Install a new gasket into the case plug (for filler) and then install the plug.

Torque:

39 N*m{398 kgf*cm, 28 ft.*lbf}

Remove the case plug (for filler) and gasket.

Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.

NOTICE:

1. When adding oil, pour it slowly.
   
2. Add oil a little at a time, waiting several minutes between each addition of oil.
   

Wait approximately 5 minutes and check that the oil level has not changed.

Install a new gasket and the case plug (for filler).

Torque:

39 N*m{398 kgf*cm, 28 ft.*lbf}