Wiper And Washer System (W/ Rain Sensor) Wiper Motor Power Source Circuit

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

INSPECT FUSE (WIP)

INSPECT IG1 RELAY

CHECK WIRE HARNESS (MOTOR - BATTERY AND BODY GROUND)

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

1. Remove the WIP fuse from the instrument panel junction block.
   

2. Measure the resistance of the fuse.
   

   Standard resistance:

   Below 1 Ω
   

1. Remove the IG1 relay from the instrument panel junction block.
   

2. Measure the resistance of the relay.
   

   Standard resistance:

   Tester Connection	Specified Condition
   3 - 5	10 kΩ or higher
   	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

1. Disconnect the A8 motor connector.
   

2. Measure the voltage of the wire harness side connector.
   

   Standard voltage:

   Tester Connection	Switch Condition	Specified Condition
   A8-2 (B) - Body ground	Ignition switch on (IG)	10 to 14 V

3. Measure the resistance of the wire harness side connector.
   

   Standard resistance:

   for LHD

   Tester Connection	Specified Condition
   A6-4 (E) - Body ground	Below 1 Ω

   for RHD:

   Tester Connection	Specified Condition
   A6-5 (E) - Body ground	Below 1 Ω