Wiper And Washer System (W/O Rain Sensor) Terminals Of Ecu

Body Electrical. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Wiper And Washer. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. CHECK HEADLIGHT CLEANER CONTROL RELAY

Wiper And Washer System (W/O Rain Sensor) -- Terminals Of Ecu



CHECK HEADLIGHT CLEANER CONTROL RELAY

Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Wiper And Washer.Wiper And Washer System (W/ Rain Sensor).Wiper And Washer System (W/O Rain Sensor) Terminals Of Ecu

  1. Disconnect the A44 relay connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    		Wiring Color
    		Terminal Description
    		Condition
    		Specified Condition
    IG (A44-3) - Body ground
    		L - Body ground
    		IG signal circuit
    		Ignition switch on (IG)
    		10 to 14 V
    Ignition switch off
    		Below 1 V
    E (A44-4) - Body ground
    		W-B - body ground
    		Body ground
    		Always
    		Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the A44 relay connector.

  4. Measure the voltage of the connector.

    Symbols (Terminal No.)
    		Wiring Color
    		Terminal Description
    		Condition
    		Specified Condition
    HDLO (A44-1) - Body ground
    		BR - Body ground
    		Headlight LO signal
    		Headlight control switch LO
    		10 to 14 V
    Headlight control switch except LO
    		Below 1 V
    H (A44-2) - Body ground
    		R - Body ground
    		Headlight cleaner switch signal
    		Headlight cleaner switch ON,
    headlight control switch LO
    		10 to 14 V
    Headlight cleaner switch ON,
    headlight control switch except LO
    		Below 1 V
    PB (A44-6) - Body ground
    		B - Body ground
    		Headlight cleaner motor signal
    		Headlight cleaner switch ON,
    headlight control switch except LO
    		10 to 14 V
    Headlight cleaner switch ON,
    headlight control switch LO
    		Below 1 V
    If the result is not as specified, the headlight cleaner control relay may be malfunctioning.