Valve Body Assembly Removal
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE NO. 1 ENGINE UNDER COVER
DRAIN AUTOMATIC TRANSAXLE FLUID
REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
REMOVE VALVE BODY OIL STRAINER ASSEMBLY
DISCONNECT TRANSMISSION WIRE
REMOVE TRANSMISSION VALVE BODY ASSEMBLY
Valve Body Assembly -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
| 3. DRAIN AUTOMATIC TRANSAXLE FLUID |
Remove the drain plug and gasket, and drain the ATF.
Install a new gasket and the drain plug.
- Torque:
- 47 N*m{479 kgf*cm, 35 ft.*lbf}
| 4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
Remove the 18 bolts, oil pan and gasket.
- NOTICE:
- Some fluid will remain in the oil pan. Carefully remove the oil pan sub-assembly.
Remove the 2 magnets from the oil pan.
Examine the particles in the pan.
Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to see the type of wear which might be found in the transaxle.
Steel (magnetic): bearing, gear and plate wear
Brass (non-magnetic): bushing wear
| 5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
Remove the 3 bolts and oil strainer.
- NOTICE:
- Perform the operation carefully as some fluid will come out from the oil strainer.
Remove the O-ring from the oil strainer.
| 6. DISCONNECT TRANSMISSION WIRE |
Disconnect the 7 connectors.
Remove the bolt and lock plate, and remove the ATF temperature sensor.
| 7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY |
Support the valve body and remove the 17 bolts and valve body.
- NOTICE:
- Do not drop the check ball body, check ball body spring or accumulator piston.
Remove the check ball body and check ball body spring.
