Cruise Control Main Switch (For 3Zr-Fae) Removal

Cruise Control System. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Cruise Control. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE STEERING PAD ASSEMBLY

  3. REMOVE CRUISE CONTROL MAIN SWITCH

Cruise Control Main Switch (For 3Zr-Fae) -- Removal



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


2. REMOVE STEERING PAD ASSEMBLY


    Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. Straighten the front wheels.

  1. Using a thin-bladed screwdriver, push open the spring clips and disengage the pins.



    Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the 2 airbag connectors.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.



3. REMOVE CRUISE CONTROL MAIN SWITCH


Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. Disconnect the connector.

  1. Remove the 2 screws and switch.