REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side)
REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side)
Parking Brake Assembly -- Disassembly |
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| 1. REMOVE REAR WHEEL |
| 2. DISCONNECT REAR DISC BRAKE CYLINDER MOUNTING LH |
Remove the 2 bolts and cylinder mounting.
 |
| 3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Remove the shoe adjusting hole plug from the rear disc.
| 4. REMOVE REAR DISC |
Put matchmarks on the disc and axle hub.
 |
Release the parking brake.
Turn the shoe adjuster until the disc turns freely, and then remove the disc.
 |
Install the shoe adjusting hole plug to the disc.
| 5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side) |
Using needle-nose pliers, remove the 2 shoe return tension springs.
 |
| 6. REMOVE PARKING BRAKE SHOE STRUT LH |
| 7. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side) |
Using needle-nose pliers, remove the tension spring.
| 8. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET |
Remove the screw set.
| 9. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH |
Press the shoe hold-down spring to remove the pin, shoe hold-down spring and shoe.
 |
| 10. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH |
Slide the shoe to remove the shoe hold-down spring, pin and shoe.
 |
Disconnect the parking brake cable from the parking brake shoe lever.
| 11. REMOVE PARKING BRAKE SHOE LEVER LH |