Door Control Transmitter Module (W/O Entry And Start System) Inspection

Body Electrical. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Door Lock. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. INSPECT DOOR CONTROL TRANSMITTER MODULE

Door Control Transmitter Module (W/O Entry And Start System) -- Inspection



1. INSPECT DOOR CONTROL TRANSMITTER MODULE


  1. Inspect operation of the transmitter.

    1. Remove the battery (lithium battery) from the transmitter.



      2. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

    2. Install a new or non-depleted battery (lithium battery).

      HINT:
      When a new or non-depleted battery is not available, first connect 2 new 1.5 batteries in series. Then connect leads to the batteries and apply 3 V to the transmitter, as shown in the illustration.

    3. From outside the vehicle, approximately 1 m (3.28 ft) from the driver side outside door handle, test the transmitter by pointing its key plate at the vehicle and pressing a transmitter switch.

      OK:
      The door lock can be operated via the transmitter.
      The LED comes on more than once.
      1. The operational area differs depending on the user, the way the transmitter is held and the location.
      2. The transmitter's faint electric waves may be affected if the area has strong electric waves or noise. The transmitter's operation area may be shortened or the transmitter may not function.


  1. Inspect the battery capacity.

    1. Remove the battery from the electrical key transmitter that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.

      NOTICE:
      Do not wrap the lead wire around a terminal, wedge it between the terminals, or solder it. A terminal may be deformed or damaged, and the battery will not be able to be installed correctly.


      2. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

    2. Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.



      3. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Door Lock.Power Door Lock Control System.Door Control Transmitter Module (W/O Entry And Start System) Inspection

    3. Using an oscilloscope, check the transmitter battery voltage waveform.

      HINT:
      Measure the transmitter battery voltage while pressing the LOCK or UNLOCK switch on the transmitter.
      Standard voltage:
      Item
      		Content
      Tester Connection
      		Battery positive (+) - Battery negative (-)
      Tool Setting
      		0.5 V/DIV., 100 ms/DIV.
      Condition
      		Ignition switch OFF, all doors closed and lock switch pushed
      Specified Condition
      		2.2 to 3.2 V (Refer to the waveform)
      If the result is not as specified, replace the transmitter battery.