Engine. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
2Gr-Fe Lubrication. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Lubrication System -- On-Vehicle Inspection |
| 1. CHECK ENGINE OIL LEVEL |
Warm up and stop the engine, and then wait for 5 minutes. The oil level should be between the dipstick low and full level marks.
If the oil level is low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not add engine oil to above the full level mark.
| 2. CHECK ENGINE OIL QUALITY |
Check the oil for deterioration, water contamination, discoloring or thinning.
If the quality is visibly poor, replace the oil.
| 3. CHECK ENGINE OIL PRESSURE |
Disconnect the oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the oil pressure switch.
 |
Install the oil pressure gauge.
 |
Warm up the engine.
Measure the oil pressure.
- Standard oil pressure:
Condition Specified Condition Idle 80 kPa (0.8 kgf/cm2, 11.6 psi) or more 6,000 rpm 380 kPa (3.9 kgf/cm2, 55.5 psi) or more
Remove the oil pressure gauge.
Apply adhesive to 2 or 3 threads of the oil pressure switch.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
 |
Install the oil pressure switch.
- Torque:
- 15 N*m{153 kgf*cm, 11 ft.*lbf}
- NOTICE:
- Do not start the engine for at least 1 hour after installation of the switch.
|
Connect the oil pressure switch connector.
Start the engine and check for engine oil leaks.