Starter Cut Relay (W/ Entry And Start System) On-Vehicle Inspection

Engine. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
1Az-Fe Starting. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE STARTER CUT RELAY

  3. INSPECT STARTER CUT RELAY

  4. INSTALL STARTER CUT RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Starter Cut Relay (W/ Entry And Start System) -- On-Vehicle Inspection



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE STARTER CUT RELAY

  1. Remove the starter cut relay from the No. 7 relay block.



3. INSPECT STARTER CUT RELAY


    Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.1Az-Fe Starting.Starting System (W/ Entry And Start System).Starter Cut Relay (W/ Entry And Start System) On-Vehicle Inspection

  1. Inspect the resistance of the relay.

    Standard resistance:
    Terminal Connection
    		Specified Condition
    3 - 5
    		10 kΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)
    If the result is not as specified, replace the relay.


4. INSTALL STARTER CUT RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL