Sfi System Dtc Check / Clear

Engine. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
3Zr-Fae Engine Control System. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

  1. CHECK FOR DTC (Using intelligent tester)

  1. CLEAR DTC (Using intelligent tester)

  1. CLEAR DTC (Without using intelligent tester)

Sfi System -- Dtc Check / Clear


NOTICE:
All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.
HINT:
  1. DTCs which are stored in the ECM can be output to the intelligent tester. The intelligent tester can display both current and pending DTCs.
  2. Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.

CHECK FOR DTC (Using intelligent tester)

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON and turn the tester on.

  3. Enter the following menus: Powertrain / Engine and ECT / DTC.

  4. Check the DTC(s) and freeze frame data, and then write them down.

  5. Check the details of the DTC(s) (RAV4_ACA30 RM000000PDF0CDX.html).


CLEAR DTC (Using intelligent tester)

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON and turn the tester on.

  3. Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

  4. Press the YES button.


CLEAR DTC (Without using intelligent tester)

  1. Perform either of the following operations:

    1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

    2. Remove the EFI MAIN and ETCS fuses from the engine room No. 1 relay block (located inside the engine compartment) for more than 1 minute.