CHECK CAN COMMUNICATION SYSTEM
READ VALUE USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH)
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL INDICATOR LIGHT)
INSPECT COMBINATION METER ASSEMBLY
INSPECT DOWNHILL ASSIST CONTROL SWITCH
CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND)
VEHICLE STABILITY CONTROL SYSTEM - Downhill Assist Control Indicator Light does not Come ON |
DESCRIPTION
Refer to the description of "Downhill Assist Control Indicator Light Remains ON" (RAV4_ACA30 RM000001S0900HX_01.html).WIRING DIAGRAM
Refer to the downhill assist control indicator light circuit (RAV4_ACA30 RM000001S0900HX_02.html).INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (RAV4_ACA30 RM000001K1O00SX.html).
1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (RAV4_ACA30 RM000001W16007X.html)
- Result:
Result Proceed to DTC is not output. A DTC is output. B
|
| ||||
A | |
2.READ VALUE USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH) |
Check the Data List for proper functioning of the downhill assist control switch.
ABS/VSC/TRC: Tester Display Measurement Item/Range Normal Condition Diagnostic Note Downhill Assist Control Switch Downhill assist control switch / ON or OFF ON: Downhill assist control switch is on
OFF: Downhill assist control switch is off- - OK:
- ON (downhill assist control switch is on) appears on the screen.
|
| ||||
OK | |
3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL INDICATOR LIGHT) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Active Test mode on the intelligent tester (RAV4_ACA30 RM000000ONK01EX.html).
ABS/VSC/TRC: Tester Display Test Part Control Range Diagnostic Note Downhill Assist Control Indicator Light Downhill assist control indicator light Indicator light ON / OFF Observe the combination meter. - OK:
- The downhill assist control indicator light turns ON and OFF.
|
| ||||
NG | |
4.INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (RAV4_ACA30 RM0000020M0001X.html).
|
| ||||
OK | ||
|
5.INSPECT DOWNHILL ASSIST CONTROL SWITCH |
![]() |
Remove the downhill assist control switch (RAV4_ACA30 RM000002101009X.html).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Switch Condition Specified Condition 4 - 1 Switch is pushed Below 1 Ω Switch is not pushed 10 kΩ or higher
|
| ||||
OK | |
6.CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND) |
![]() |
Disconnect the skid control ECU connector.
Disconnect the downhill assist control switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition A67-29 (HDCS) - E36-4 Always Below 1 Ω A67-29 (HDCS) - Body ground Always 10 kΩ or higher E36-1 - Body ground Always Below 1 Ω
|
| ||||
OK | ||
|