Audio And Visual System Gateway Ecu Communication Error

INSPECTION PROCEDURE

IDENTIFY THE COMPONENT SHOWN BY SUB-CODE

CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE

INSPECT RADIO RECEIVER

CHECK HARNESS AND CONNECTOR (GATEWAY ECU - COMPONENT SHOWN BY SUB-CODE)

REPLACE COMPONENT SHOWN BY SUB-CODE

INSPECTION PROCEDURE

1. Enter the diagnostic mode.
   

   
   
   
   

2. Press the preset switch "3" to change to "Detailed Information Mode".
   

3. Identify the component shown by the sub-code.
   

HINT:

1. "190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.
   

1. For details of the DTC display, refer to "DTC CHECK/CLEAR" (Click here).
   

1. Inspect the power source circuit of the component shown by the sub-code.
   If the power source circuit is operating normally, proceed to the next step.
   
   

   Component Table:

   Component	Proceed to
   Integration control & panel assembly (1D8)	Integration control & panel assembly power source circuit (Click here)
   Stereo component amplifier (440)	Stereo component amplifier power source circuit (Click here)
   Radio receiver (190)	Radio receiver power source circuit (Click here)

1. Disconnect the radio receiver connectors.
   

2. Measure the resistance according to the value(s) in the table below.
   

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   ATX+ - ATX-	Always	60 to 80 Ω
   TXM+ - TXM-	Always	60 to 80 Ω
   TX+ - TX-	Always	60 to 80 Ω

HINT:

1. Start the check from the circuit that is near the component shown by the sub-code first.
   

1. For details of the connectors, refer to the "TERMINALS OF ECU" (Click here).
   

1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the gateway ECU and the component shown by the sub-code.
   

   1. Disconnect all connectors between the gateway ECU and the component shown by sub-code.
      

   
   
   

   2. Check for an open or short in the AVC-LAN circuit between the gateway ECU and the component shown by the sub-code.
      

      OK:

      There is no open or short circuit.
      

      
      
      
      

1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
   

   OK:

   Same problem does not occur.