Driver Side Knee Airbag Assembly -- Installation |
| 1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY |
Connect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
 |
Install the driver side knee airbag assembly with the 4 bolts.
- Torque:
- 10 N*m{102 kgf*cm, 7 ft.*lbf}
| 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Connect the connectors.
 |
Engage the 7 clips and install the lower instrument panel finish panel sub-assembly.
| 3. INSTALL NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Connect the connectors.
 |
Insert the No. 1 instrument panel under cover sub-assembly into the guide as shown in the illustration.
Engage the 2 claws.
Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <E>.
| 4. INSTALL INSTRUMENT SIDE PANEL |
Engage the 5 claws and 3 clips, and then install the side instrument panel LH.
 |
| 5. INSTALL FRONT DOOR OPENING TRIM COVER |
Engage the 6 claws and install the front door opening trim cover LH.
 |
| 6. INSTALL FRONT DOOR SCUFF PLATE (w/o Illumination) |
Engage the 4 clips.
 |
Engage the 7 claws, and install the front door scuff plate LH.
 |
| 7. INSTALL FRONT DOOR SCUFF PLATE (w/ Illumination) |
Connect the connector.
Engage the 4 clips.
|
Engage the 7 claws, and install the front door scuff plate LH.
|
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. PERFORM INITIALIZATION |
Perform initialization (Click here).
- HINT:
- Some systems need initialization after reconnecting the cable to the negative battery terminal.
| 10. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).