Engine. Lexus Is250, Is220D. Gse20 Ale20
4Gr-Fse Engine Mechanical. Lexus Is250, Is220D. Gse20 Ale20
Drive Belt -- Installation |
1. INSTALL V-RIBBED BELT |
Install the V-ribbed belt.
![]() |
While turning the belt tensioner counterclockwise, remove the bar.
- NOTICE:
- Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
- Check that the V-ribbed belt is properly set to each pulley.
If it is difficult to install the V-ribbed belt, perform the following procedure.
Put the V-ribbed belt on every part except the tensioner pulley as shown in the illustration.
While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
- NOTICE:
- Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
- Check that the V-ribbed belt is properly set to each pulley.
![]() |
2. INSTALL V-BANK COVER SUB-ASSEMBLY |
Engage the 2 clips on the front of the cover, and then engage the clip on the rear to install the V-bank cover.
- NOTICE:
- Be sure to engage the clips securely.
- Do not apply excessive force or do not hit the cover to engage the clips. This may cause the cover to break.
![]() |
3. INSTALL NO. 1 INLET AIR CLEANER |
Install the inlet air cleaner with the bolt.
- Torque:
- 5.0 N*m{51 kgf*cm, 44 in.*lbf}
![]() |
4. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the intake duct seal with the 11 clips.
![]() |